| IconNMR Automation Run Status: | |
| Day Experiments: | 00:00 |
| Busy Until: | Fri 11:51 |
| Night Experiments: | 00:00 |
| Holder | Status | Name | ExpNo | Experiment | User | Time | Title |
| 16 | Completed | 260123-iconnmr | 1 | N sst.1H.lsh 1H Lineshape: CHCl3 in d6-Acetone Specification result of humpcal: Linewidth at 0.55% of signal height ( < 7 Hz) Linewidth at 0.11% of signal height ( < 14 Hz) Halfwidth ( < 0.7 Hz) | iconnmr | 00:01:13 | Supervisor Thomas |
| 17 | Completed | 260123-iconnmr | 2 | N sst.1H.sen 1H Sensitivity 0.1% Ethyl Benzene in CDCl3 Specification result of sinocal: Best sino value found ( > 1050:1) | iconnmr | 00:01:02 | Supervisor Thomas |
| 18 | Completed | 260123-iconnmr | 3 | N sst.13C.sen 13C Sensitivity 10% Ethylbenzene in CDCl3 Specification result of sinocal: Best sino value found ( > 475:1) | iconnmr | 00:05:04 | Supervisor Thomas |
| Holder | Time | Name | ExpNo | Experiment | User | Load | Atma | Spin | Lock | Shim | Acq | Proc | Title | Remarks |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 18 | 09:45:33 | 260123-iconnmr | 3 | sst.13C.sen | iconnmr | + | + | - | + | + | + | + | Supervisor Thomas | Automation was stopped by user |
| 17 | 09:33:27 | 260123-iconnmr | 2 | sst.1H.sen | iconnmr | + | + | - | + | + | + | + | Supervisor Thomas | |
| 16 | 09:23:41 | 260123-iconnmr | 1 | sst.1H.lsh | iconnmr | + | x | - | + | + | + | + | Supervisor Thomas | ATM Failed, humpcal: Hump: at 0.11%: between 4822.8 and 4811.5 Hz = 11.3 Hz at 0.55%: between 4820.7 and 4814.8 Hz = 5.9 Hz at 50%: Half width at 4818.6 Hz = 0.56 Hz, humpcal: Hump: at 0.11%: between 4822.8 and 4811.5 Hz = 11.3 Hz at 0.55%: between 4820.7 and 4814.8 Hz = 5.9 Hz at 50%: Half width at 4818.6 Hz = 0.56 Hz |
| 1 | 14:24:07 | AutoCalibrate | + | - | - | - | - | + | - | AutoCalibrate: Success | ||||
| 1 | 14:22:31 | AutoCalibrate | x | - | - | - | - | - | - | SampleJet: OP_CHANGER Command refused: System is in manual mode , AutoCalibrate - Sample could not be inserted | ||||
| 1 | 14:09:51 | AutoCalibrate | x | - | - | - | - | - | - | SampleJet: OP_CHANGER Command refused: Error recovery required , AutoCalibrate - Sample could not be inserted |